Tapping Screw Points and Head Styles in Phillips, Hex or Slotted Drive

Tapping Screw Points and Head Styles Available in Phillips, Hex or Slotted Drive
Over 100,00 Different Line Items for Delivery

Range

• #0-3" to 10" long

• M3 thru M24 thru 250mm long

Materials

• Brass
• Aluminum
• Copper
• Steel

• Silicone-Bronze
• Alloy Steel
• Stainless Steel
(all series)

Processes

Both primary and secondary
capabilities for:

• Thread Rolling

• Slotting
• Shank Slotting
• Trimming
• Pinch Pointing

• Broaching
• Drilling

• End Slotting

• SEMs

• TEKs

Market Advantage

• Any Head
• Any Drive
• Standard and Metric
• Multiple Secondary Operations
• Long and Short Run Capabilities
• Stock and Release Programs
• Rush Order

							Tapping Screw Points
Round General Purpose (see pan head)	Pan Recommended to replace round, truss, or binder heads	Oval Undercut Similar to flat undercut with rounded surface	Square Bolts on large bearing surface for wrench tightening	Oval Same as flathead with rounded surface for appearance	Hex Washer Same as flat head with rounded surface for appearance	Binding Under-cut unless otherwise specified not recommended for phillips recess

Flat 82° Used where flush surface is desired	Square (Set screw) recommended for high torque assembly	Flat Trim Same as 82° except diameter and countersink depth reduced	Flat Undercut Standard 82° with lower 1/3 counter sink removed for short screws	Round Washer Same as round head with integral washer for bearing surface	Square Countersink for use on plow bolts	Fillister Deep slot use for counterbored holes

Flat Fillister Same as standard fillister without oval top	Hexagon Manufactured as trim hex or indented hex	Truss Similar to round head with larger diameter (see Pan Head)	Round Counter Sink Bolts on similar to flat head with no driving recess	Flat 100° Larger head than 82° - used for thin metal or soft plastic	Oval Trim Same as Oval smaller diameter and countersink	Combo Pan Combination phillips and slot both functional